Table of Contents
Advertisement
3.4 SIM/M2 FLEX MODULE AND KEY FLEX CABLE
Figure 15 1) Flat nut, 2) SIM/M2 flex Module and 3) key flex cable.
Figure 16 Flip up the display holder and loosen the screw that holds the green
card holder by screwing it 2,5 turns. Remove the flat nut (arrow).
APPENDIX
Setup & Maintenance Instructions for W890 TRS Fixture
Figure 17 Insert the SIM/M2 flex module by sliding it into position under the
green card holder. The red arrows points at the flat nuts that mark the end
position for the SIM/M2 flex module.
Figure 18 Connect the key flex cable (arrow) point and slide it into position under
the green card holder. Stabilise but do not fixate the flex cable and SIM/M2 flex
module by adding the flat nut.
Figure 19 Insert the PBA and connect it with the key flex cable.
SEMC Troubleshooting Manual
W890
1217-3942 rev. 1
116
(119)
Advertisement
Table of Contents
Troubleshooting
