Advertisement
Electric Cooktop Installation
Install the Cooktop
Attach the foam strip to the underside of the cooktop
frame. Refer to the illustration below. For unframed
cooktops, be sure to adhere the foam strip to the outer
edge of the glass-ceramic top, not the support frame.
Gently lower the unit into the cut-out area in the counter-
top and center. Check that the front edge of cooktop is
parallel to the front edge of the countertop. Check that all
required clearances are met.
Attach the brackets to the bottom of the cooktop, as
shown in the illustration below. Install clamping screws
into the brackets and tighten until the screws contact the
underside of the countertop. Do not overtighten screws.
IMPORTANT NOTE: Do not seal the cooktop to the coun-
tertop. It must be removed if service is necessary.
COOKTOP FRAME
FOAM
STRIP
Foam strip.
COUNTERTOP
BRACKET
4"
BRACKET
(102)
SCREWS
CLAMPING
SCREW
Installation brackets.
Verify Cooktop Operation
Before operating the electric cooktop, be sure to read the
entire use & care guide included with the cooktop for
important safety, operating and warranty information.
Clean the glass-ceramic surface as recommended in the
electric cooktops use & care guide. The cooktop surface
must be free of any foreign substances, especially those
that could melt and permanently adhere to the glass-
ceramic.
Turn on the electrical supply to the cooktop. Check opera-
tion of the controls and verify that each of the heating
elements is coming up to temperature.
IMPORTANT NOTE: A small amount of smoke and odor
may be noticed during the initial break-in period.
Do not operate the cooktop if the glass-ceramic surface
is broken. Call a Wolf authorized service center.
Cooktop Removal
IMPORTANT NOTE: Cooktop removal should only be done
by a Wolf authorized service center technician.
If it is necessary to remove the cooktop for cleaning or
service, disconnect the electrical supply. Remove the
mounting brackets and remove the cooktop. Reinstall in
the reverse order.
For flush mount installations, use a razor blade to carefully
cut around the perimeter seal. A new RTV installation kit
will be required to reinstall the cooktop. This kit and other
accessories are available through your authorized Wolf
dealer. To obtain local dealer information, visit the find a
showroom section of our website, wolfappliance.com.
14
Advertisement
