Removing And Replacing The Flip Hinge - Motorola W510 Service Manual

Disassembly

Removing and Replacing the Flip Hinge

30
18. Align the display module to the flip assembly & then insert the receiver into the slot
provided.
19. Insert the display bracket.
20. Insert the Flex cable to the slot of the connector on flip PCB.
21. Replace the display bracket, camera assembly, flip assembly cover, transceiver board, rear
housing, antenna, SIM, battery, and battery connector as described in the procedures.
1. Remove the battery cover, battery, SIM, memory card, rear housing, and transceiver board
assembly as described in the procedures.
2. Insert the tweezer under the knuckle cap lock.
3. Turn the tweezer outward to disassemble the cap lock.
4. Open and close the flip and make the right knuckle come out
5. Insert the jig to the slot over the flex.
Figure 19. Removing the Flip Hinge
March 01, 2007
061431o
6809509A89-O