SMC Networks EtherPower II 1000 User Manual page 24

5. When prompted to "Select a Network Adapter," click on "Have
Disk." Insert the SuperDisk when prompted and click on "OK."
6. You are presented with the "Select OEM Option" window.
Highlight "EtherPower II 1000" and click on "OK."
7. When prompted to "Search for an Adapter," click on "Next."
8. Select network protocols when prompted and click "Next."
Note: To complete a TCP/IP installation, you will need to know
your IP Address and Subnet Mask. For further information,
contact your network administrator or Internet service
provider.
9. Click on "Next" and then "Next" again when prompted to
"Install Network Components." When prompted for Windows
NT files, type the path to your Windows NT files on CD-ROM
(e.g., D:\WINNT), or change the path to those files on your
hard drive, and click on "OK."
10. You are presented with the "Network Card Setup" window
where you can specify the network card data rate.
"AUTONEGOTIATE" is the recommended setting for the
EtherPower II 1000 network card. Select "Continue" after
verifying network card settings.
11. Click on "Next" and then "Next" again when prompted to
"Start the Network."
12. Enter the "Workgroup" or "Domain" names (optional) when
prompted and click on "Next."
13. Select "Finish" when prompted and click on "Yes" when
prompted to reboot. Remove the SuperDisk.
I N
NSTALLING ETWORK
D
RIVERS
2-3