SMC Networks EtherPower II 1000 User Manual page 18

Figure 1-3. Inserting the Network Card
4. Replace the chassis cover on your PC and power it on.
5. The EtherPower II 1000 card should be automatically
configured by the host computer's BIOS. However, if you have
an older computer, you may have to manually configure the
computer's BIOS settings.
6. The SMC SuperDisk that accompanies the EtherPower II 1000
contains all the network operating system drivers supported by
this card. Please read the "RELEASE.TXT" file on the diskette
for a list of all drivers. Refer to Chapter 2 in this guide for
instructions on installing drivers. Also, a text file is included
with each driver to detail the proper installation procedure.
Any new or updated drivers can be downloaded from SMC's
Web site (see the back cover of this guide).
I
NSTALLING THE
N C
ETWORK ARD
1-7