Electrical Safety; Unpacking Your Saw; Familiarization; Specifications - DeWalt DW713-XE Instruction Manual

Electrical Safety

The electric motor has been designed for one voltage only. Always check that the power supply corresponds
to the voltage on the rating plate. 230 V AC means your tool will operate on alternating current. As little as 10%
lower voltage can cause loss of power and can result in overheating. All D
tool does not operate, check the power supply. Your D
required.
• Young children and the infirm. This appliance is not intended for use by young children or infirm persons
without supervision. Young children should be supervised to ensure that they do not play with this appliance.
• Replacement of the supply cord. If the supply cord is damaged, it must be replaced by the manufacturer or
an authorised D WALT Service Centre in order to avoid a hazard.
E

Unpacking Your Saw

Check the contents of your miter saw carton to make sure that you have received all parts. In addition to this
instruction manual, the carton should contain:
1. One No. DW713 miter saw with blade.
2. One blade wrench in wrench pocket shown in Figure 2.
3. One No. DW7053 Dust Bag.

Familiarization

Your miter saw is fully assembled in the carton.Open the box
and lift the saw out by the convenient carrying handle, as
shown in Figure 1.
Place the saw on a smooth, flat surface such as a workbench
or strong table.
Examine Figures 2 and 3 to become familiar with the saw and
its various parts. The section on adjustments will refer to these
terms and you must know what and where the parts are.
CAUTION: Pinch Hazard. To reduce the risk of injury, keep
thumb underneath the handle when pulling the handle down.
The lower guard will move up as the handle is pulled down
which could cause pinching.
Press down lightly on the operating handle and pull out the lock down pin, as shown in Figure 4. Gently release
the downward pressure and allow the arm to rise to its full height. Use the lock down pin when carrying the saw
from one place to another. Always use the carrying handle to transport the saw or the hand indentations shown in
Figure 3.

Specifications

CAPACITY OF CUT
50 degree miter left and right
48 degree bevel left: 3 degree right
0 degree miter
Max. Height 88.9 mm (3.5") Result Width 88.9 mm (3.5")
Max. Width 154.9 mm (6.1") Result Height 31.8 mm (1.25")
45 degree miter
Max. Height 88.9 mm (3.5") Result Width 61.0 mm (2.4")
Max. Width 106.7 mm (4.2") Result Height 31.8 mm (1.25")
45 degree bevel
Max. Height 58.4 mm (2.3") Result Width 88.9 mm (3.5")
Max. Width 154.9 mm (6.1") Result Height 19.0 mm (0.75")
31.62 degree miter and 33.85 bevel
Max. Width 33.4 mm (5.25") Result Height 22.9 mm (0.9")
DRIVE
230 Volt Motor
1600 Watts Cut Helical Gears with Roller and Ball Bearings
5000 RPM Automatic Electric Brake
Carbide Tooth Blade
WALT tools are factory tested; if this
E
WALT tool is double insulated, therefore no earth wire is
E
FIG. 1
DW7080
LOCKNUTS
END PLATE
DW7051
TOP HOLE
(USE IF ON LEFT
SIDE)
KNOBS
BOTTOM HOLE
(USE IF ON RIGHT SIDE)
BRACKET
4
MATERIAL
CLAMP
DW7084
DW7187
DWS7085