ENGLISH HEAVY-DUTY MITRE SAW DW713 CAUTION: Indicates a potentially hazardous situation Congratulations! which, if not avoided, may result in minor or moderate You have chosen a D WALT tool. Years of experience, thorough injury . product development and innovation make D...
ENGLISH 4. Keep other persons away. unless otherwise indicated in this instruction manual. Have defective switches replaced by an authorized service centre. Do not let persons, especially children, not involved in the work, Do not use the tool if the switch does not turn it on and off. touch the tool or the extension cord and keep them away from the Never attempt any repairs yourself.
• Only fit 13 Amperes BS1363A approved plugs fitted with the The DW713 mitre saw is a professional power tool. DO NOT let children correctly rated fuse (1). come into contact with the tool. Supervision is required for those under 16 years of age.
Page 14
ENGLISH WARNING: NEVER use a light socket. 3. Gently release the downward pressure and allow the arm to rise to its full height. NEVER connect the live (L) or neutral (N) wires to the earth Bench Mounting (fi g. 5) pin marked E or 1.
Page 15
ENGLISH Adjustments 6. If the bevel pointer (xx) does not indicate zero on the bevel scale (q), loosen the screw (yy) that secures the pointer and move the WARNING: To reduce the risk of injury, turn off tool pointer as necessary. and disconnect from power source before attempting to ADJUSTING THE FENCE (FIG.
ENGLISH The attention of UK users is drawn to the “woodworking 3. Always ensure that the mitre lock lever is locked tightly before machinesregulations 1974” and any subsequent amendments. cutting. 4. Proceed as for a vertical straight cross-cut. Prior to operation WARNING: When mitring the end of a piece of wood with •...
Page 17
ENGLISH No. of sides Angle mitre or bevel • When mitring to the right: 45° -increase the mitre angle by moving the arm to align the appropriate vernier mark with the closest mark on the mitre scale to 36° the right. 30°...
ENGLISH 5. Mitre right. WARNING: Never use solvents or other harsh chemicals for cleaning the non-metallic parts of the tool. These chemicals 6. Save the right side of the cut. may weaken the materials used in these parts. Use a cloth dampened only with water and mild soap.
Page 35
DW713 WALT WALT DW713 220~240 1,600 EC-Declaration of conformity min-1 5,000 90° 45° 90° DW713 45° WALT declares that these products, described under “technical 50° data” have been designed in compliance with 50° 98/37/EC (until Dec.28,2009); 2006/42/EC(from Dec.29,2009); 48° 2004/108/EC; 2006/95/EC; EN 61029-1:2000 + A11:2003 48°...