Table of Contents
Advertisement
SAS/SATA or SCSI
Hard Drive
4
Drive
Carrier
3.
Install a new drive into the carrier with the printed circuit board side facing
down so that the mounting holes align with those in the carrier.
4.
Secure the hard drive by tightening all six screws.
5.
Replace the drive carrier into the chassis bay, making sure that the drive car-
rier handle is completely closed.
5
Warning! Enterprise level hard disk drives are recommended
for use in Supermicro chassis and servers. For information on
!
recommended HDDs, visit the Supermicro Web site at http://
www.supermicro.com/products/nfo/files/storage/SAS-1-Com-
pList-110909.pdf
Chapter 5: Chassis Setup and Maintenance
Figure 5-5: Removing the Hard Drive
Figure 5-6: Installing the Hard Drive
5-5
4
Advertisement
Table of Contents
