Yamaha YFM4FAR Service Manual page 81

ADJUSTING THE STARTER CABLE
3 - 18
2.Adjust:
*****************************************************
Adjustment steps:
Disconnect the starter cable 1 from the
G
carburetor body.
NOTE:
Do not remove the starter plunger 2 from the
starter cable.
G
Measure the starter plunger stroke distance
a of the starter lever 3 fully close to fully
open position. If the distance is out of
specification adjust it as described below.
Starter plunger stroke distance:
15 mm (0.59 in)
È Fully closed position
É Fully open position
Pull back the boot 4.
G
Loosen the locknut 5.
G
Turn the adjuster 6 in or out until the correct
G
free play is obtained.
Turning in Free play increased.
Turning out Free play decreased.
Tighten the locknut 5.
G
Push in the boot 4.
G
G
Connect the starter cable to the carburetor.
WARNING
After adjusting
handlebar to right and left, and make sure
that the engine idling speed does not
increase.
*****************************************************
3.Install:
Fuel tank side panel (left)
G
Seat
G
Refer to "SEAT, CARRIERS, FENDERS
AND FUEL TANK".
CHK
ADJ
the cable, turn the