Yamaha YFM4FAR Service Manual page 215

MIDDLE GEAR
G
Tighten the bearing retainer.
CAUTION:
The middle driven shaft bearing retainer
has left-handed threads. To tighten the
bearing retainer, turn it counterclockwise.
Bearing retainer:
110 Nm (11.0 m • kg, 80 ft • lb)
*****************************************************
3.Install:
Shims 1
G
Bearing housing
G
NOTE:
Install the shims so that the tabs are positioned
as shown in the illustration.
4.Install:
Universal joint yoke (rear side)
G
Washer
G
Nut 1
G
LT
NOTE:
Use the universal joint holder 2 to hold the
yoke.
Universal joint holder:
P/N. YM-04062, 90890-04062
5.Install:
Universal joint
G
*****************************************************
Installation steps:
G
Install the opposite yoke into the U-joint.
G
Apply wheel bearing grease to the bearings.
4 - 85
ENG
97 Nm (9.7 m • kg, 70 ft • lb)