Lock Washers/Plates And Cotter Pins; Bearings And Oil Seals; Circlips - Yamaha YFM4FAR Service Manual

IMPORTANT INFORMATION
EB101030
LOCK WASHERS/PLATES AND COTTER
PINS
1.Replace all lock washers/plates 1 and cotter
pins after removal. Bend lock tabs along the
bolt or nut flats after the bolt or nut has been
tightened to specification.
EB101040

BEARINGS AND OIL SEALS

1.Install bearings and oil seals so that the
manufacturer's marks or numbers are visible.
When installing oil seals, apply a light
coating of lightweight lithium base grease to
the seal lips. Oil bearings liberally when
installing, if appropriate.
1 Oil seal
CAUTION:
Do not use compressed air to spin the
bearings dry. This will damage the bearing
surfaces.
1 Bearing
EB101050

CIRCLIPS

1.Check
reassembly. Always replace piston pin clips
after one use. Replace distorted circlips.
When installing a circlip 1, make sure that
the sharp-edged corner 2 is positioned
opposite the thrust 3 it receives. See
sectional view.
4 Shaft
1 - 3
GEN
INFO
all circlips carefully before