Adjusting Backlight; Using The Freeze Function; Using The Pip (Picture-In-Picture) Function - BenQ SH3741 Installation And Operation Manual

before expiration in the
Timer" on page
will display on-screen as a reminder. You can press any button on the remote
control to reset the sleep timer and the display will remain on. To turn off this
function, set the time to 0 minute.

Adjusting backlight

To adjust the intensity of your display's backlight system, press
(Backlight)
on the remote control to select a suitable level.
When viewing the display in dimly lit rooms it is recommended to set the
backlight to Dark
areas of the image darker thus maintaining a high contrast image in a dark
environment. If
be activated and the display's backlight will be changed automatically
according to the ambient lighting condition.

Using the freeze function

Press 畫面靜止 (Freeze)
screen. Press it again to restore normal viewing.
• This function does not control the input source which will continue normally,
but not be displayed whilst the image remains frozen. When the image freeze is
stopped, normal play will resume in real time. That is, the displayed image will
jump to the current time and any interim video is not displayed.
• In PIP mode, this function can only freeze the motion of the sub picture.
Do not leave the screen displaying a static image for an extended period of time
(days) as doing so may temporarily or permanently damage the screen resulting
in image traces which could remain visible long after the original image has been
removed.

Using the PIP (Picture-In-Picture) function

If the display is connected to either a TV antenna or Video image source, and
also to an active Graphic image source at the same time, you can display both
images on the screen simultaneously by using PIP (Picture-In-Picture) mode.
• PC or DVI must be selected as one of the input sources in PIP mode.
• In PIP mode, some of the remote control functions will be unavailable.
1. Press 訊號來源 (Input)
source (PC or DVI) as the input source.
2. Press 子母畫面 (Picture In Picture)
to PIP mode. Each press cycles the display through the following display
sequence:
Full screen
• To change the input source for the sub picture, press
remote control.
The sub picture cannot display Component Video (AV1 and AV2) input signals.
Sleep Timer
23). 1 minute before the expiration of the set time, a message
which will reduce the image brightness and make the dark
Auto is selected, the ambient light sensor on the display will
on the remote control to freeze the image on the
on the remote control to select a Graphic image
PIP mode
item in the Setup menu (See
on the remote control to switch display
訊號來源 (Input)
Using the remote control
"Sleep
背光亮度
Full screen
on the
11