Checking The Fuses - Pfaff 8303-040 Instruction Manual

12

Checking the fuses

.13
Fig. 12 - 12
Change fuses F1/F2, F300, F301 or F302 as required.
To change the fuses, pull out the fuse box on the right side of the machine base.
When pushing the fuse box back into position, make sure that no wires are trapped.
Poti
R400
R401
R402
R403
R404
R405
R3
R407
F301: incoming/outgoing
F300: Control
The purpose of the fuses is to provide protection against major damage in case
of a short-circuit or overload.
Disconnect the mains plug!
Danger from electric voltage!
Before switching the machine on again, first eliminate the cause of the fault!
Function
Time: Hot air engaged/feed roller on
Time: Drive, tape dispenser off
Time: Feed roller lowered
Time: Feed roller reverse off (foot switch pos. 2 free)
Time: Feed roller raised/tape feed on
Time: +/- Correction for disengaging hot air after cutting tape
Time: Hot air disengaged/feed roller reverse on
F302: Heating
Poti's R 400 - 407
Adjustment
F1/F2
(230V, 6,3Amp.)
12 - 13