Lenovo ThinkCentre 7244 Hardware Maintenance Manual page 67

Diagnostic Error Code
030-027-XXX SCSI interface Configuration/Setup error
030-03X-XXX 030-04X-XXX SCSI interface error
030-195-XXX SCSI interface Test aborted by user
030-196-XXX SCSI interface test halt, error threshold
exceeded
030-197-XXX SCSI interface test warning
030-198-XXX SCSI interface test aborted
030-199-XXX SCSI interface test failed, cause unknown
035-000-XXX RAID interface Test Passed
035-0XX-XXX RAID interface Failure
035-195-XXX RAID interface Test aborted by user
035-196-XXX RAID interface test halt, error threshold
exceeded
FRU/Action
1. SCSI signal cable
2. Flash the system. See "Updating (flashing) BIOS
from a disc" on page 560
3. SCSI device
4. SCSI adapter card, if installed
5. System board
1. SCSI signal cable
2. Check power supply
3. SCSI device
4. SCSI adapter card, if installed
5. System board
Information only Re-start the test, if necessary
1. Press F3 to review the log file
2. Re-start the test to reset the log file
1. Make sure the component that is called out is
connected and/or enabled. See Chapter 6 "Using
the Setup Utility" on page 43
2. Re-run test
3. Replace the component that is called out in warning
statement
4. Replace the component under test
1. If a component is called out, make sure it is
connected and/or enabled. See Chapter 6 "Using
the Setup Utility" on page 43
2. Flash the system and re-test. See "Updating
(flashing) BIOS from a disc" on page 560
3. Go to "Undetermined problems" on page 69
1. Go to "Undetermined problems" on page 69
2. Flash the system and re-test. See "Updating
(flashing) BIOS from a disc" on page 560
3. Replace component under function test
No action
1. RAID signal cable
2. RAID device
3. RAID adapter card, if installed
4. System board
Information only Re-start the test, if necessary
1. Press F3 to review the log file
2. Re-start the test to reset the log file
Chapter 7
.
Symptom-to-FRU index
59