Lenovo ThinkCentre 7244 Hardware Maintenance Manual page 63

Diagnostic Error Code
014-015-XXX Parallel port External Loopback failure
014-027-XXX Parallel port Configuration/Setup error
014-03X-XXX 014-04X-XXX Parallel port failure
014-195-XXX Parallel port Test aborted by user
014-196-XXX Parallel port test halt, error threshold
exceeded
014-197-XXX Parallel port test warning
014-198-XXX Parallel port test aborted
014-199-XXX Parallel port test failed, cause unknown
014-2XX-XXX 014-3XX-XXX Parallel port failure
015-000-XXX USB port Interface Test Passed
015-001-XXX USB port Presence
015-002-XXX USB port Timeout
015-015-XXX USB port External Loopback failure
015-027-XXX USB port Configuration/Setup error
015-032-XXX USB port Device Controller failure
015-034-XXX USB port buffer allocation failure
FRU/Action
1. Wrap plug
2. System board
1. Run Setup, enable port
2. Flash the system. See "Updating (flashing) BIOS
from a disc" on page 560
3. System board
System board
Information only Re-start the test, if necessary
1. Press F3 to review the log file
2. Re-start the test to reset the log file
1. Make sure the component that is called out is
connected and/or enabled. See Chapter 6 "Using
the Setup Utility" on page 43
2. Re-run test
3. Replace the component that is called out in warning
statement
4. Replace the component under test
1. If a component is called out, make sure it is
connected and/or enabled
2. Flash the system and re-test. See "Updating
(flashing) BIOS from a disc" on page 560
3. Go to "Undetermined problems" on page 69
1. Go to "Undetermined problems" on page 69
2. Flash the system and re-test. See "Updating
(flashing) BIOS from a disc" on page 560
3. Replace component under function test
1. External parallel device
2. System board
No action
1. Remove USB device(s) and re-test
2. System board
1. Remove USB device(s) and re-test
2. System board
1. Remove USB device(s) and re-test
2. System board
1. Flash the system. See "Updating (flashing) BIOS
from a disc" on page 560
2. System board
System board
1. Reboot the system
2. Flash the system and re-test. See "Updating
(flashing) BIOS from a disc" on page 560
3. Run memory test
4. System board
Chapter 7
.
Symptom-to-FRU index
55