Chapter 4. Completing The Parts Replacement; Cable Routing - Lenovo ThinkCentre 7098 Hardware Installation Manual

Chapter 4. Completing the parts replacement

After replacing the parts, you need to close the cover and reconnect cables,
including telephone lines and power cords. Also, depending on the part that was
replaced, you might need to confirm the updated information in the Setup Utility
program. Refer to "Using the Setup Utility program" in the User Guide for this
product.
To complete the parts replacement:
1. Ensure that all components have been reassembled correctly and that no tools
2. Make sure that the cables are routed correctly before lowering the drive-bay
Figure 35. Cable routing
3. Lower the drive-bay assembly and position the drive locks to the locked
4. Close the computer cover.
5. If a cover lock is installed, lock the cover.
6. Reconnect the external cables and power cords to the computer. See "Locating
© Lenovo 2005, 2008. Portions © IBM Corp. 2005.
or loose screws are left inside your computer. See "Locating components" on
page 8 for the location of various components.
assembly.
Important
Correctly route all power supply cables to avoid interference with the
drive bay assembly. Keep cables clear of the hinges and sides of the
computer chassis.
position. Otherwise, you cannot close the computer cover.
connectors on the rear of your computer" on page 6.
39