Lenovo ThinkCentre 7098 Hardware Installation Manual page 29

5. Reinstall the PCI-riser assembly if removed.
6. Lower the drive-bay assembly and reconnect any cables that were
disconnected.
7. Close the computer cover and connect the power cord. See Chapter 4,
"Completing the parts replacement," on page 39.
8. Restart the computer, leave it on for approximately 10 seconds. Turn off the
computer by holding the power switch for approximately 5 seconds. The
computer will turn off.
9. Repeat steps 1 through 3 on page 20.
10. Move the Clear CMOS/Recovery jumper back to the standard position (pins 1
and 2).
11. Reinstall the PCI-riser assembly if removed.
12. Close the computer cover and connect the power cord. See Chapter 4,
"Completing the parts replacement," on page 39.
Chapter 3. Installing options and replacing hardware
21