Connecting Drives; Connecting The First Optical Drive - Lenovo 8097 User Manual

6. Install a retainer bracket on the side of the drive.
7. Install the drive into the bay until it snaps into position.
8. Continue at "Connecting drives."

Connecting drives

The steps to connect a drive are different depending on the type of drive. Use one
of the following procedures for your drive connection.

Connecting the first optical drive

1. The drive requires two cables; a power cable that connects to the power supply
2. Locate the three-connector signal cable that comes with your computer or with
3. Locate the PATA IDE connector on the system board. See "Identifying parts on
4. Connect one end of the signal cable to the drive and the other to the PATA IDE
5. Locate the extra four-wire power connector labelled P4 and connect it to the
20
User Guide
and a signal cable that connects to the system board.
the new drive.
the system board" on page 11.
connector on the system board. To reduce electronic noise, use the connectors at
the end of the cable only.
drive.