6. For a 5.25-inch drive, install a retainer bracket on the side of the drive.
7. For a 3.5-inch drive, install the drive into the Universal Adapter Bracket, 5.25 to
8. Install the drive into the bay until it snaps into position.
9. Continue at "Connecting drives" on page 20.
Installing a hard disk drive in bay 3
1. Remove the computer cover. See "Removing the cover" on page 10.
18
User Guide
v If there is a combination of optical and parallel ATA hard disk drives in bays
1 and 2, set the hard disk drive as a master device and the optical drive as a
slave device.
Refer to the documentation that comes with your drive for master/slave
jumper information.
3.5-inch.
Note: If you are installing the adapter bracket, install the screws that secure the
bracket in the bay.