Connecting Drives - Lenovo THINK CENTRE 9126 Guida Alla Sostituzione E All’installazione Dell’hardware Manual

Figura 14. Retaining bracket
6. Install the drive into the drive bay until it snaps into position.
Figura 15. Installing the drive
7. Align the drive bay assembly with the two slots and rails on the sides of the

Connecting drives

The steps to connect a drive are different depending on the type of drive that you
are connecting. Use one of the following procedures for your drive connection.
Connecting an optical drive or a parallel ATA hard disk drive:
1. Locate the two-connector signal cable that comes with your computer or with
2. Locate the IDE connector 1 on the system board. See "Identifying parts on the
3. Connect one end of the signal cable to the drive and the other to the IDE
4. Locate the extra four-wire power connector labelled P4 and connect it to the
Figura 16. Connecting a parallel ATA hard disk drive
Connecting an additional serial ATA hard disk drive: A serial hard disk drive
can be connected to any available SATA connector.
1. Locate the signal cable that comes with the new drive.
Nota: When installing the Universal Adapter Bracket, if the retaining bracket is
not available, install the screws to secure the adapter bracket into the drive bay.
chassis and connect the new drive cable on the system board. See "Connecting
drives".
the new drive.
system board" a pagina 7.
connector 1 on the system board.
drive.
Capitolo 3. Installing options and replacing hardware
17