Installing A Memory Module - Lenovo 8097 User Manual

The following illustration shows the locations of parts on the system board.

Installing a memory module

Your computer has four connectors for installing dual inline memory modules that
provide up to a maximum of 4.0 GB of system memory.
Note: Addressable memory might be less than total supported memory.
System memory is divided into two channels (channel A and B). Memory module
connectors 1 and 2 are designated as channel A, and memory module connectors 3
and 4 are designated as channel B. If memory modules are present in both
channels, your computer operates in dual channel mode.
Your computer has either double data rate (DDR) or double data rate 2 (DDR2)
memory. The type of memory required depends on the system board that is
installed.
12
User Guide
1
12V power connector
2
Diskette drive connector
3
Speaker connector
4
Memory module connector 4
5
Memory module connector 3
6
Memory module connector 2
7
Memory module connector 1
8
Clear CMOS/Recovery jumper
9
Front Panel connector
10
PATA IDE connector
11
SATA 4 IDE connector
12
SATA 3 IDE connector
13
SATA 2 IDE connector
14
SATA 1 IDE connector
15
Cover presence switch connector
16
Power supply connector
17
PCI Express x16 graphics adapter
connector
18
PCI Express x1 adapter connector
19
PCI connector
20
PCI connector
21
Battery
22
Microprocessor
23
Microprocessor fan connector
24
Microprocessor heat sink