Troubleshooting - JVC KD-X320BT Instruction Manual

TROUBLESHOOTING

Symptom
Sound cannot be heard. • Adjust the volume to the optimum level.
• Check the cords and connections.
"MISWIRING CHECK WIRING
THEN PWR ON" appears.
"PROTECTING SEND
SERVICE" appears.
Source cannot be selected.
• Radio reception is poor. • Connect the antenna firmly.
• Static noise while listening • Pull the antenna out all the way.
to the radio.
Playback order is not as
intended.
Elapsed playing time is not
correct.
"NOT SUPPORT" appears and
file skips.
"READING" keeps flashing. • Do not use too many hierarchical levels and folders.
• Reattach the USB device.
"CANNOT PLAY" flashes and/ • Check whether the connected device is compatible with
or connected device cannot
be detected.
• Reattach the device.
The iPod/iPhone does not • Check the connection between this unit and iPod/
turn on or does not work.
• Detach and reset the iPod/iPhone using hard reset.
Correct characters are not
displayed.
Remedy
Turn the power off, then check to be sure the terminals
of the speaker wires are insulated properly. Turn the
power on again.
Send the unit to the nearest service center.
Check the [SRC SELECT] setting. ( 4)
The playback order is determined by the file name
(USB).
This depends on the recording process earlier.
Check whether the file is a playable format. ( 17)
this unit and ensure the files are in supported formats.
( 17)
iPhone.
This unit can only display uppercase letters, numbers,
and a limited number of symbols. Uppercase Cyrillic
letters can also be displayed if [РУССКИЙ] is selected.
( 4)
Symptom Remedy
• Sound cannot be heard • Reconnect the Android device.
during playback. • If in [AUDIO MODE], launch any media player application
• Sound output only on the Android device and start playback.
from the Android • If in [AUDIO MODE], relaunch the current media player
device. application or use another media player application.
• Restart the Android device.
• If this does not solve the problem, the connected Android
device is unable to route the audio signal to unit. ( 18)
Cannot playback at • Make sure JVC MUSIC PLAY APP is installed on the Android
[AUTO MODE]. device. ( 5)
• Reconnect the Android device and select the appropriate
control mode. ( 6)
• If this does not solve the problem, the connected Android
device does not support [AUTO MODE]. ( 18)
"NO DEVICE" or • Switch off the developer options on the Android device.
"READING" keeps • Reconnect the Android device.
flashing. • If this does not solve the problem, the connected Android
device does not support [AUTO MODE]. ( 18)
Playback is intermittent Turn off the power saving mode on the Android device.
or sound skips.
"CANNOT PLAY" • Make sure Android device contains playable audio files.
• Reconnect the Android device.
• Restart the Android device.
19
ENGLISH