Display Settings - JVC KD-X320BT Instruction Manual

AUDIO SETTINGS
AMP GAIN LOW POWER: Limits the maximum volume level to 30. (Select if the
maximum power of each speaker is less than 50 W to prevent damaging
the speakers.) ; HIGH POWER: The maximum volume level is 50.
D.T.EXP ON: Creates realistic sound by compensating the high-frequency
(Digital Track components and restoring the rise-time of the waveform that are lost in
Expander) audio data compression. ; OFF: Cancels.
SPK/PRE OUT Selects the appropriate setting to get the desired output. (See the
following table.)
SPK/PRE OUT
Connection via lineout terminals (
Setting
FRONT
REAR/REAR Front speakers output
REAR/SUB.W Front speakers output
SUB.W/SUB.W Front speakers output
Connection via speaker leads (
Setting
L (left)
REAR/REAR Rear speakers output
REAR/SUB.W Rear speakers output
SUB.W/SUB.W Subwoofer output
If [SUB.W/SUB.W] is selected:
– [HIGH 120HZ] is selected in [SUB.W LPF] and [THROUGH] is not available.
– [R01] is selected in [FADER] and selectable range is [R06] to [00]
16
23 )
Lineout terminal
REAR/SW
Rear speakers output
Subwoofer output
Subwoofer output
)
23
Rear speaker lead
R (right)
Rear speakers output
Rear speakers output
(Mute)

DISPLAY SETTINGS

1
Press and hold
2
Turn the volume knob to make a selection (see the following table),
then press the knob.
3 2
Repeat step until the desired item is selected/activated or follow
the instructions stated on the selected item.
4
Press to exit.
To return to the previous setting item, press
DISPLAY
DIMMER Selects the display and button illumination adjusted in the [BRIGHTNESS]
setting.
OFF: Selects the day adjustments. ; ON: Selects the night adjustments. ;
DIMMER TIME: Adjusts the dimmer on and off time.
Turn the volume knob to adjust the [ON] time, then press the knob.
Turn the volume knob to adjust the [OFF] time, then press the knob.
(Default: [ON]: 18:00 or 6:00 PM
[OFF]: 6:00 or 6:00 AM)
AUTO: Changes between the day and night adjustments when you turn off or
on the car headlights. *
* 1
The illumination control wire connection is required. ( 23)
.
.
1
Default: XX