Dial-In Direct Digits
FXS Reverse
Tone Setting
Line Detect
Caller ID
Voice TX Gain
(-48db ~
24db)
Voice RX Gain
(-48db ~
24db)
Click [Submit] to confirm the change. Click [Cancel] to restore the previous value.
4.5.4 Restore Setting
Select Restore Setting from the Administrator Setting menu.
When you select "Restore" you will see the following display:
To restore all the parameters back to factory default setting, click "Default Setting?". However dialing
plan and IP address will remain the same.
the port belonging to this group is not used with FXO and FXS,
either).
DID set as PBX is set up by 0-4. If 0 is chosen, it will be set as
4. Usually, a setup of PBX is followed
A specific signal indicating the status of the
conversation.
Adjust the tone frequency according to each
country.
On Hook Detect, Off Hook Detect, Hook Flash
Detect: On Hook, Off Hook, and Hook timing
setting. Line detect basically detects the current
phone status.
Setup by area code.
Sets a specific sound intensity for transmitting
sound.
Sets a specific sound intensity for receiving
sound.
27