Sony DAV-F200 Operating Instructions Manual page 14

5
Reconnect the speaker cords to the speakers.
The connector and color tube of the speaker cords are the same color as the label of the jacks to be
connected. Be sure to match the speaker cords to the appropriate terminals on the speakers: the
speaker cord with the color tube to 3, and the speaker cord without the color tube to #. Do not
catch the speaker cord insulation in the speaker terminals.
Connector
6
Fasten the screws to the wall.
5 to 7 mm
7
Hang the speakers on the screws.
Rear of the speaker
Note
• Use screws that are suitable for the wall material and strength. As a plaster board wall is especially fragile, attach
the screws securely to a beam and fasten them to the wall. Install the speakers on a vertical and flat wall where
reinforcement is applied.
• Contact a screw shop or installer regarding the wall material or screws to be used.
• Sony is not responsible for accident or damage caused by improper installation, insufficient wall strength or
improper screw installation, natural calamity, etc.
14
GB
Rear of speaker
Color tube
(+)
(–)
Color tube
Front speaker (L): White
Front speaker (R): Red