Connecting The Cords - Brother S-7300A-333P Instruction Manual

3-4. Connecting the cords

Contact your Brother dealer or a qualified electrician
for any electrical work that may need to be done.
Do not connect the power cord until all cords have
been connected.
The machine may operate if the treadle is depressed
by mistake, which could result in injury.
3-4-1. Connecting the cords
Lower the tab (7).
Push in securely until the tabs (7)
engage.
CAUTION
When securing the cords, do not bend the cords
excessively or fasten them too hard with staples,
otherwise there is the danger that fire or electric
shocks could occur.
Be sure to connect the ground. If the ground
connection is not secure, you run a high risk of
receiving a serious electric shock, and problems with
correct operation may also occur.
0887D
0888D
S-7300A
3. INSTALLATION
1. Harness cover
1. Raise the harness cover (1).
2. Cords (1)
(1) Harness cover
(2) Sewing machine motor encoder
connector 16-pin
(3) Feed motor encoder connector
6-pin
(4) Hand switch connector 12-pin
(5) 10-pin operation panel connector
(6) 10-pin solenoid connector
1. Pass the cords through the harness
cover (1).
2. Connect the cords to the control
box.
NOTE:
For Europe specifications, Americas
220V specifications and 100V/400V
system specifications, refer to "3-4-2.
Other cords".
8