Connecting The Cords - Brother T-8421D Instruction Manual

Connecting the cords

• Wait at least 5 minutes after turning off the power switch and disconnecting the power cord from the
wall outlet before opening the control box cover. Touching areas where high voltages are present
can result in severe injury.
• Do not connect the power cord until all cords have been connected. The machine may operate if the
treadle is depressed by mistake, which could result in injury.
• When securing the cords, do not bend the cords excessively or fasten them too hard with staples.
Otherwise, fire or electric shocks may occur.
• Contact your Brother dealer or a qualified electrician for any electrical work that may need to be
done.
• Be sure to connect the ground. If the ground connection is not secure, you run a high risk of
receiving a serious electric shock, and problems with correct operation may also occur.
Opening the control box cover
1
Remove the top four of the six
screws with washer (1), and
loosen the bottom two.
(1) Screw with washer [6
pcs.]
(2) Cover
2
Open the control box cover.
Securing the cords
3
Push the tab (2) and remove
the cable tie (1).
(1) Repeat cable tie
(2) Tab
4
Use the cable tie (1) to secure
the cords.
DANGER
CAUTION
10