Installation; Carrying The Machine; Tilting Back The Machine Head - Brother S-7300A-333P Instruction Manual

3. INSTALLATION

3. INSTALLATION
Machine installation should only be carried out by a
qualified technician.
Contact your Brother dealer or a qualified electrician
for any electrical work that may need to be done.
The sewing machine weighs approximately 34.5 kg
(76lb). The installation should be carried out by two
or more people.
Do not connect the power cord until installation is
complete. The machine may operate if the treadle is
depressed by mistake, which could result in injury.
About the machine set-up location
・ Do not set up this sewing machine near other equipment such as
televisions, radios or cordless telephones, otherwise such
equipment may be affected by electronic interference from the
sewing machine.
・ The sewing machine should be plugged directly into an AC wall
outlet. Operation problems may result if extension cords are
used.

Carrying the machine

・ The sewing machine should be carried by the arm and the pulley
cover by two people as shown in the illustration.
* Do not hold by any part other than the pulley cover. If this is not
observed, it may result in damage to the sewing machine.
* Do not hold the operation panel.

Tilting back the machine head

・ Hold section (A) with your foot so that the table does not move,
and then push the arm with both hands to tilt back the machine
head.
* Do not push the operation panel.
Returning the machine head to the upright position
1. Clear away any tools, etc. which may be near the table holes.
2. While holding the face plate with your left hand, gently return the
machine head to the upright position with your right hand.
* Do not hold the operation panel.
3
CAUTION
Secure the table so that it will not move when tilting
back the machine head. If the table moves, it may
crush your feet or cause other injuries.
Use both hands to hold the machine head when
tilting it back or returning it to its original position. If
only one hand is used, the weight of the machine
head may cause your hand to slip, and your hand
may get caught.
S-7300A
0475D
0877D
0878D
0879D