Paper Is Not Cut; Depression On The Leading Edge Is Left; The Size Of Clear Film Cannot Be Detected - Canon iPF755 User Manual

Cause
Paper rises by the ends of the cut position
before it is cut.
You are using paper that cannot be cut with
the Cutter Unit.
Cut Speed is not configured correctly in the
Control Panel menu.
During cutting, printed documents fall out at
an angle.

Paper is not cut

Cause
In the printer driver, No or Print Cut Guideline
is specified in Auto Cut.
In the Control Panel menu, Cutting Mode is set
to Eject or Manual.

Depression on the leading edge is left

Cause
Keeping a roll in the printer for a long
time without printing on it may leave a
depression on the leading edge.

The size of clear film cannot be detected

Cause
The Platen is soiled with ink or other substances.
iPF755
Troubleshooting
Corrective Action
Reload the paper correctly.
Specify Manual in Cutting Mode in the Control Panel menu and
use scissors or a cutting tool to cut the roll after printing.
(See "Specifying the Cutting Method for Rolls.")
Change the Cut Speed setting in the Control Panel menu.
(See "Menu Structure.")
In the Control Panel menu, set Cutting Mode to Eject. Hold docu-
ments after printing, as they are cut.
(See "Specifying the Cutting Method for Rolls.")
Specify Yes in Auto Cut in the printer driver.
If the Cutting Mode is Eject, press the Cut button to cut the
paper.
If the Cutting Mode is Manual, cut rolls with scissors or the
like.
Corrective Action
When printing quality is most important, we recommend setting Tri-
mEdge Reload to On or Automatic so that the paper edge is automati-
cally cut before printing.
(See "Menu Structure.")
→P.657
Corrective Action
Open the Top Cover and clean the entire Platen.
(See "Cleaning Inside the Top Cover.")
> Problems Regarding Paper
→P.602
→P.657
→P.602
Corrective Action
→P.757
Paper is not cut
>
12
777