Lennox Hearth Products Traditions T300P Series Installation And Operation Manual page 15

INSTALLATION
Installation Configurations / Standard Venting Options
This appliance may be connected to an existing flue or
by installing listed type "PL" vent pipe. If a liner is run all
the way to the top of the existing chimney, the existing
flue should be sealed with a steel plate. Start a vertical
run with a Tee at the back of the stove. Other options
are illustrated below. Note: See page 11 for Vent Termi-
nation Requirements.
Preferred Installation – Vertical Vent Through the Roof.
This venting configuration allows for the best stove
performance. The vertical pipe promotes natural draft
and with the chimney inside the dwelling, the flue
gases stay warm, thus rising at a consistent rate.
PAGE 15