Adding Salt - Currys Essentials CDW60W13 Instruction Manual

Adding Salt

If the water in your area is hard, deposits will form on your dishes and
utensils. This appliance contains a salt reservoir for you to reduce the
hardness of the water.
Please follow the steps below to pour the salt into the salt reservoir and
it must be set to correspond to the water hardness level in your area.
1. Remove the lower basket and unscrew the reservoir cap.
2. Fill the reservoir with approximately 500ml of water (first use
only).
3. Place the funnel provided over the salt reservoir.
4. Pour in approximately 1.2kg of dishwasher salt depending on
the brand used.
5. Clean any excess salt from around the reservoir opening and
then screw the cap on again firmly.
6. Run the "Rapid" wash programme immediately (without any
crockery in the dishwasher) to remove any traces of salt from
the compartment.
• Salt refill warning indicator will illuminate when the reservoir is running out of salt and requires refilling.
• The salt refill warning indicator will cease to illuminate within a few days, depending on how quickly the salt
dissolves.
• If you decide to use a detergent tablet, you may not need to add salt, this depends upon the water hardness
in your area and the type of tablet being used. Check with your water supplier and the detergent tablet
manufacturer's instructions.
open
open
open
19