Adjusting The Rinse Aid Reservoir; Adding Salt - Currys Essentials CID60W12 Instruction Manual

Adjusting the Rinse Aid Reservoir

The rinse aid reservoir has six settings. Both the recommended
setting and the factory setting is "4. " If the dishes are not drying
properly or are spotted, adjust the dial to the next higher number
until your dishes are spot-free.
If you decide to use a detergent tablet, you may not
need to add rinse aid into the rinse aid reservoir.

Adding Salt

If the water in your area is hard, deposits will form on your dishes and utensils. This appliance contains a
salt reservoir for you to reduce the hardness of the water.
Please follow the steps below to pour the salt into the salt reservoir. It must be set to correspond to the
water hardness level in your area.
1. Remove the lower basket and unscrew the reservoir cap.
2. Place a funnel (not included) over the salt reservoir. Pour in
approximately 1 kg to 2 kg of dishwasher salt.
3. Fill the reservoir with water until it overflows (first use only).
4. Clean any excess salt from around the reservoir opening and then
screw the cap on again firmly.
5. Run the "Prewash" programme P4 immediately (without any
crockery in the dishwasher) to remove any traces of salt from the
compartment.
• The salt low warning indicator on the control panel will
illuminate when the reservoir is running out of salt and
requires refilling.
• The salt low warning indicator will cease to illuminate within
a few days, depending on how quickly the salt dissolves.
* All images are for reference only; please refer to your individual unit for actual item.
18
open
open
open