Wiring Diagrams; Warranty; Product Reference Information - Lennox Hearth Products LMDTV-3328CNM Homeowner's Care And Operation Instructions Manual

WIRING DIAGRAMS

Wiring diagrams are provided here for refer-
ence purposes only. This information is also
provided on schematics attached directly to the
appliance on a pullout panel located within the
control compartment.
CAUTION
Label all wires prior to discon-
nection when servicing con-
trols. Wiring errors can cause
improper and dangerous appli-
ance operation.
Millivolt Wiring Diagram
Schematic Representation Only
If any of the original wire as supplied must
be replaced, it must be replaced with Type
o
AWM 105 C - 18 gage wire.
Thermopile
*Optional Switch
Standard OFF/ON Switch
* Optional Kits Installed - OFF/ON wall switch,
wall thermostat or remote control receiver.
Note: Turn the appliance-mounted OFF/ON
burner control switch to the OFF position if
any of these kits are installed.
Figure 16
Your Fireplace's Model Number ________________________________________
Your Fireplace's Serial Number ________________________________________
The Date On Which Your Fireplace Was Installed ___________________________
The Type of Gas Your Fireplace Uses ____________________________________
Your Dealer's Name ________________________________________________
Electronic Wiring Diagram (Honeywell) Showing Blower Wiring for Optional FBK-100, FBK-200 & FBK-250 Kits
Auxiliary View A
J-Box Wiring when
using unit mounted
relay module.
BK
W
G
Junction Box
Pilot Burner
Assembly
BL
BL
BK
Optional Control Switch
Figure 17

WARRANTY

Your gas appliance is covered by a limited
twenty year warranty. You will fi nd a copy
of the warranty accompanying this manual.
Field Wired
Please read the warranty to be familiar with
Factory
its coverage.
Wired
Retain this manual. File it with your other
documents for future reference.

PRODUCT REFERENCE INFORMATION

We recommend that you record the following
important information about your fi replace.
Please contact your Lennox dealer for any
questions or concerns. For the number of
your nearest Lennox dealer, please call 1-800-
9-LENNOX.
Visit us at www.Lennox.com
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
Schematic Representation Only
Relay Module C/W FBK-250 only. Plug blower
into J-Box receptacle for FBK-100 or FBK-200
application. View A for J-Box wiring.
Optional Blower
*OFF/ON Switch
(Integral with
Gas Valve)
Honeywell
Electronic
Gas
Valve
Igniter
Connector
GROUND
Transformer
BL
R
24 V
Secondary
BK
BK = BLACK BL = BLUE
BK
R = RED W = WHITE
W
G = GREEN
Field Wired
Factory
Wired
Wall Mounted Blower Speed Control Switch or
ON/OFF Switch for Blower Kit (optional)
Outlet Box Green
Ground Screw
BK
120
W
VAC
G
Break off Tab
Junction
Hot side
Box
of Outlet
* Leave the OFF/ON switch, which is
integral with the gas valve, in the ON
position.
**Optional Control Switches: Wall
Switch, Wall Thermostat or Remote
Control Receiver.
120 VAC
Notes:
Primary
1. If any of the original wire as supplied
must be replaced, use Type AWM 105°C
- 18 gage wire ONLY.
2. 120 VAC, 60 Hz - Less than 3 Amps.
Caution: label all wires prior to
disconnection when servicing controls.
Wiring errors can cause improper and
dangerous operation.
REPLACEMENT PARTS
A complete parts list is found at the end of
this manual. Use only parts supplied from the
manufacturer.
Normally, all parts should be ordered through
your Lennox distributor or dealer. Parts will be
shipped at prevailing prices at time of order.
When ordering repair parts, always give the
following information:
1. The model number of the appliance.
2. The serial number of the appliance.
3. The part number.
4. The description of the part.
5. The quantity required.
6. The installation date of the appliance.
If you encounter any problems or have any ques-
tions concerning the installation or application
of this system, please contact your distributor,
or Lennox directly:
LENNOX HEARTH PRODUCTS
1110 West Taft Avenue
Orange, CA 92865
G BK
R
White Wire
to Opposite
Side (neutral)
13