Wiring Diagrams; Warranty; Replacement Parts; Product Reference Information - Lennox Hearth Products Montebello LSM40MN-2 Care And Operation Instructions Manual

WirinG diaGraMs

Wiring diagrams are provided here for refer-
ence purposes only. This information is also
provided on schematics attached directly to the
appliance on a pullout panel located within the
control compartment.
caution: LaBeL aLL Wires prior to dis-
connection WHen serVicinG controLs.
WirinG errors can cause iMproper and
danGerous appLiance operation.
Millivolt Wiring Diagram
If any of the original wire as supplied must be replaced,
it must be replaced with Type AWM 105 C – 18 GA. wire.
Thermopile
APPLIANCE-MOUNTED ON/OFF SWITCH
*OR OPTIONAL WALL-MOUNTED ON/OFF SWITCH OR
OPTIONAL REMOTE CONTROL RECEIVER
*Turn the appliance-mounted ON/OFF burner control switch
to the OFF position if an optional
control switch is installed.
Schematic Representation Only
Figure 10

WarrantY

Your gas appliance is covered by a limited twenty
year warranty. You will find a copy of the war-
ranty accompanying this manual. Please read
the warranty to be familiar with its coverage.
Retain this manual. File it with your other docu-
ments for future reference.

product reFerence inForMation

We recommend that you record the following important information about your fireplace. Please
contact your Lennox Hearth Products dealer for any questions or concerns. For the number of
your nearest Lennox Hearth Products dealer, please call 1-800-9-LENNOX
Your Fireplace's Model Number ________________________________________
Your Fireplace's Serial Number ________________________________________
The Date On Which Your Fireplace Was Installed ___________________________
The Type of Gas Your Fireplace Uses ____________________________________
Your Dealer's Name ________________________________________________
12
piLot Burner
iGniter-sensor
asseMBLY
connector
Field Wired
Factory Wired
Figure 11

repLaceMent parts

A complete parts list is found at the end of
this manual. Use only parts supplied from the
manufacturer.
Normally, all parts should be ordered through
your Lennox Hearth Products distributor or
dealer. Parts will be shipped at prevailing prices
at time of order.
WHite
eV2 eV1
Gas VaLVe
BLue (20)
Ground
BLacK (20)
Green Led
eLectronic iGnition
controL Board
eLectronic
optionaL
WirinG diaGraM
accessorY sW
red
Gnd
W
BLK
Junction BoX
BLK
W
WHite (6)
appLiance Mounted
on/oFF sWitcH
BLacK (16)
*WaLL Mounted on/oFF sWitcH (optionaL)
or reMote controL receiVer
*turn the appliance-Mounted on/oFF Burner control switch
to the oFF position if an optional control switch is installed
FieLd Wired
With proper care and maintenance, your appli-
ance will provide many years of enjoyment. If
you should experience any problem, first refer
to the troubleshooting guide in this manual. If
problem persists, contact your Lennox Hearth
Products dealer or distributor.
Normally, all parts should be ordered through
your Lennox Hearth Products distributor or
dealer. Parts will be shipped at prevailing prices
at time of order.
When ordering repair parts, always give the
following information:
1. The model number of the appliance.
2. The serial number of the appliance.
. The part number.
4. The description of the part.
5. The quantity required.
6. The installation date of the appliance.
If you encounter any problems or have any
questions concerning the installation or ap-
plication of this system, please contact your
dealer or distributor.
LennoX HeartH products
1110 West taft avenue
orange, ca 92865
visit us at www.Lennox.com
120 Vac
BLK
W
Gnd
transF
120 V.
24 V.
FactorY Wired