York PV9A12N040UP11 Technical Manual
York PV9A12N040UP11 Technical Manual

York PV9A12N040UP11 Technical Manual

York pv9 series gas-fired condensing / high efficiency two stage variable upflow furnaces

Advertisement

Quick Links

TECHNICAL GUIDE
AFFINITY
MODELS: PV9
GAS-FIRED
CONDENSING / HIGH EFFICIENCY
TWO STAGE VARIABLE
UPFLOW FURNACES
UP TO 94% AFUE
NATURAL GAS
40 - 120 MBH INPUT
EFFICIENCY
RATING
CERTIFIED
Due to continuous product improvement, specifications
are subject to change without notice.
Visit us on the web at www.york.com for the most
up-to-date technical information.
Additional rating information can be found at
www.gamanet.org.
FOR DISTRIBUTION USE ONLY - NOT TO BE USED AT POINT OF RETAIL SALE
DESCRIPTION
These Category IV, highly efficient, compact, condensing
type furnaces are designed for residential and commercial
installations in a basement, closet, alcove, recreation room
or garage where the ambient temperature is above 32°F, or
higher. They may be either side wall or thru-roof vented
using approved plastic type combustion air and vent piping.
All units are factory assembled, wired and tested to assure
dependable and economical installation and operation.
WARRANTY
Lifetime limited warranty on both heat exchangers to the
original purchaser; a 20-year limited warranty from original
installation date to subsequent purchaser.
10-year warranty on the heat exchanger in commercial appli-
cations.
5-year limited parts warranty.
FEATURES
• Two stage heating operation includes:
• Provides increased comfort level & very quiet unit opera-
• Adjustable delay timer allows two stage operation with
• Compact, easy to install, ideal height 40" cabinet
• Blower-off delay for cooling SEER improvement.
• Easy to connect power/control wiring.
• Built-in, high level self diagnostics with fault code display.
• Low unit amp requirement for easy replacement applica-
• Integrated control module for reliable, economical opera-
• May be installed as either two-pipe (sealed combustion)
• Top intake & vent connection allows installation in narrow
• Electronic Hot Surface Ignition saves fuel cost with
• Induced combustion system with inshot main burners for
• No special vent termination kit required.
• 100% shut off main gas valve for extra safety.
• 24V, 40 VA control transformer and blower relay supplied
• Hi-tech tubular aluminized steel primary heat exchanger.
• Secondary (condensing) heat exchanger of 29-4C high-
ISO 9001
• Timed on, adjustable off blower capability for maximum
Certified Quality
Management System
• Solid removable bottom panel allows easy application.
• Easy access from front of unit for cleaning, maintenance
• Protection from intake, exhaust or condensate blockage.
• Insulated blower compartment for quiet operation.
• ClimaTraK comfort system allows dealer to customize
- Two stage gas valve
- Two stage inducer operation
- Variable speed ECM blower operation
tion
single stage thermostat
tion.
tion.
or single pipe vent (using indoor combustion air)
locations.
increased dependability and reliability.
quiet, efficient operation.
for add-on cooling.
grade stainless steel.
comfort.
or service.
comfort settings based on regional location.
036-21584-002 Rev. A (1205)

Advertisement

Table of Contents
loading

Summary of Contents for York PV9A12N040UP11

  • Page 1 • Protection from intake, exhaust or condensate blockage. Visit us on the web at www.york.com for the most up-to-date technical information. • Insulated blower compartment for quiet operation. • ClimaTraK comfort system allows dealer to customize Additional rating information can be found at comfort settings based on regional location.
  • Page 2: Cabinet And Duct Dimensions

    BOTTOM IMAGE TOP IMAGE RETURN END SUPPLY END CABINET AND DUCT DIMENSIONS Cabinet Dimension Nominal Cabinet Models Size A (in.) B (in.) C (in.) D (in.) PV9A12N040UP11 1200 14-1/2 13-1/2 12-1/8 6-1/4 PV9B12N060UP11 1200 17-1/2 16-1/4 15-1/8 8-1/2 PV9B12N080UP11 1200...
  • Page 3: Electrical And Performance Data

    Nominal Airflow* Total Unit AFUE High/Low High/Low Width Rise Models Amps °F 40/26 38/24 1200 14-1/2 94.0 35 - 65 PV9A12N040UP11 60/39 56/36 1200 17-1/2 93.2 40 - 70 PV9B12N060UP11 80/52 75/49 1200 17-1/2 92.5 45 - 75 PV9B12N080UP11 80/52...
  • Page 4: Air Flow Data

    036-21584-002 Rev. A (1205) AIR FLOW DATA HIGH / LOW SPEED COOLING AND HEAT PUMP CFM 40,000 INPUT - 3 Ton 60,000 INPUT - 3 Ton JUMPER SETTINGS High High COOL Tap ADJ Tap 1340 1330 1205 1130 1255 1220 1150 1040 1170...
  • Page 5: Filter Sizes

    036-21584-002 Rev. A (1205) FILTER PERFORMANCE APPLYING FILTER PRESSURE DROP TO DETERMINE SYSTEM AIRFLOW The airflow capacity data published in the “Blower Perfor- mance” table listed above represents blower performance To determine the approximate airflow of the unit with a filter in WITHOUT filters.
  • Page 6 036-21584-002 Rev. A (1205) For additional connection diagrams for all UPG equipment refer to “Low Voltage System Wiring” document available online at www.upgnet.com in the Product Catalog Section. Thermostat Chart - AC Unitary Products Group...
  • Page 7 036-21584-002 Rev. A (1205) Thermostat Chart - HP Unitary Products Group...
  • Page 8 * For the most current accessory information, refer to the price book or consult factory. Subject to change without notice. Printed in U.S.A. 036-21584-002 Rev. A (1205) Copyright © by York International Corp. 2005. All rights reserved. Supersedes: 036-21584-001 Rev. C (0205) Unitary 5005...

This manual is also suitable for:

Pv9b12n080up11Pv9c16n080up11Pv9b12n060up11Pv9c20n100up11Pv9d20n120up11

Table of Contents