Making Connections; Connection With Computer - Oki Operation 790 Handbook

Ribbon
shield
Headgap lever
Setting
position
1
2
3
4
5
M
Headgap lever

Making Connections

Connection with Computer

There instructions are for the standard parallel interface and USB interface. Instructions
for installation/connection of a serial interface are included with the serial interface ac-
cessory. For more information on the serial interface accessory, see Chapter 5.
6
Knob
Number of
sheets
1 1
2 2
3 3
4 4
5 envelopes or
extra-thick paper
Printhead
1
Knob
2
3
3. Holding ribbon cartridge with knob fac-
ing up and ribbon sheild facing platen,
fit grooves on either side at back end of
cartridge over pins on ribbon plate.
4. Lower front of cartridge over printhead
until it snaps into place, then turn knob
in direction of arrow (clockwise) to take
up ribbon slack.
5. The headgap lever by the side of cartridge
adjusts for different paper thicknesses.
Set it for the number of sheets in the
forms you're using from 1 to 4; use set-
ting 5 for envelopes or extra-thick pa-
per. Adjust the setting up or down for
the best print quality.
Note: When the setting is set at 2~5, the
printer automatically slows down for better
print quality with thicker multipart forms.
Important!
Be sure to use only ribbons
specifically for use with MICROLINE 790
series.
For best results, use genuine OKI ribbons.
Installation