Maintenance; Environmental Information - Flymo Minitrim ST Original Instructions Manual

WARNING Disconnect from the mains electricity supply before attempting any maintenance or adjustment.
FAULT
LINE NOT FEEDING
OR
LINE TOO SHORT
OR
TRIMMER VIBRATES
CONTINUOUS
CLATTERING NOISE
LINE SNAPS CONTINUOUSLY
IF NONE OF THE ABOVE
OR IF FAULT PERSISTS
After you have finished using your trimmer follow the pro-
cedure below:
1. Disconnect from the mains electricity supply.
2. Never clean your trimmer with water, cleaning fluids,
or solvents, just remove debris with a suitable tool, a
soft brush or dry cloth.
3. Using a soft brush, clean around the inside of the
safety guard, the cutting head and the motor housing
air vents. (Fig T, V).
4. Inspect the trimmer carefully, especially the parts of
the cutting head.
5. If your trimmer is damaged in any way contact your
local approved service centre.
• Never use a damaged trimmer.
6. Store in a cool, dry place and out of reach of children.
Cable Storage
1. Your mains cable can be stored on the product as il-
lustrated in Fig W.
2. Wind cable carefully to avoid kinking.
• Awareness of the environment must be considered
when disposing of ʻend-of-lifeʼ product.
• If necessary, contact your local authority for disposal in-
formation.
The symbol on the product or on its packaging indicates
that this product may not be treated as household waste. In-
stead it shall be handed over to the applicable collection point
for the recycling of electrical and electronic equipment. By en-
Fault Finding Chart (Automatic Line Feed only)
Is the automatic line feed working?
Is the line fed out and visible? Has
line been removed from cleat?
Is the manual line feed working?
Has the motor reached full
speed before use?
Has too much line been fed out?
Is the line cutter missing from the
safety guard?
Are you using the trimmer correctly?
Is the line jamming on the spool?
Contact Husqvarna UK Ltd. Customer Service
Telephone : 01325 300303

Environmental Information

CHECK

Maintenance

T
V
suring this product is disposed of correctly, you will help prevent
potential negative consequences for the environment and
human health, which could otherwise be caused by inappropri-
ate waste handling of this product. For more detailed informa-
tion about recycling of this product, please contact your local
council office, your household waste disposal service or the
shop where you purchased the product.
ACTION
Manually feed out line.
No
Remove cap and spool, free line
No
and re-fit spool and cap.
The line may be jammed on the
No
spool. Rewind line to remove
crossed loops. Check that line is in
correct section of spool.
Allow the motor to reach full speed
No
before use
Yes
Rewind line.
Contact your local approved Service
Yes
Centre or Husqvarna UK Ltd. Cus-
tomer Service.
?
Only use tip of nylon line to trim.
Rewind the line on the spool, if symptoms
Yes
still persist, change spool and line.
W