Toyota SP200 Series Instruction Manual page 21

Using the needle threader
z
1
While fully lowering the needle
threader lever, hook the thread
on the guide as shown in the
diagram.
2
Fully turn the needle threader
lever to the rear, and pull the
thread through the needle
threader slot.
Slowly return the needle threader
1
lever towards yourself as much
as possible.
Check that the thread has passed
2
through the eye of the needle.
Release the needle threader lever
3
while releasing the end of the
thread.
If the needle is not threaded, check
*
that the needle has been raised to its
highest position, and then repeat the
procedure starting with step
Pull the thread loop that formed behind the needle, and then pull about
15 cm of thread to the rear.
Needle threader
lever
.
1
15 cm
Guide
Needle threader slot
2
21