Caution
While the bobbin is being wound, do not touch the thread winding
spindle or the handwheel.
Doing so could cause an injury.
Spool cap
Spool of thread
Felt
Spool pin
Spool pin (
)
2
Thread winding spindle
(
Hold the thread end and push the thread
1
winding switch to the left and start winding.
After winding a little, release the thread
2
winding switch to the right and stop winding.
Note
While pushing the winding switch to the
left, thread winding spindle rotates.
Thread winding switch
(
)
7
8
)
6
8
Main power
switch (
)
1
Pull the thread from the thread
spool, and then hold it with
one hand while passing it
around the thread guide with
the other hand, as shown.
Thread guide
Pass the thread end through
the hole in the bobbin as
shown.
Place the bobbin on the
thread winding spindle so the
groove aligns with the shaft
projection.
Hole
Thread
winding
spindle
2
Thread
Groove
Bobbin
Shaft
projection
15