MON (Monitor) Mode
6-2
MON (Monitor) Mode
Procedure
1,2,3...
Reading Judgment
NG will be displayed when reading
is not performed correctly or reading
data is not coincident with registered
data for coincidence judgments 0 to
3.
Data obtained
Note The light will become dimmer gradually as it is used, so adjust the
Confirms whether the reading can be correctly performed with the set
conditions.
The reading judgment and data are not output to the terminal blocks
or RS-232C but displayed on a monitor.
1.
Enter MON (Monitor) mode.
MON (monitor) mode is automatically moved to by leaving SET
mode using the ESC Key.
2.
Input reading trigger.
• Console
One reading is performed when the TRIG Key is pressed
once.
• Terminal Block page 35
• RS-232C page 56, page 83
reading conditions periodically. If an Intelligent Light Source is
Displayed Images.
Press the SHIFT + Up/Down Keys to switch images.
Section 6-2
Reading Time
183