Table of Contents
Advertisement
Installation
System Diagram
UTP Junction Box Link Setup
1. SDC-435U → 4Ch Junction Box → 4Ch Receiver → DVR/Monitor/Controller
The maximum power transmission distance for the camera is 300m, and the distance
between the camera and the 4ch Receiver cannot exceed 1.0km.
SUP-400
300m or Less
SDC-435U
1.0Km or Less
2. UTP Receiver Link Setup(Additional Power input is needed)
SDC-435U → 1Ch Passive Receiver → DVR → Monitor
300m or Less
1Ch Passive Receiver
14
COLOR CCD CAMERA
RS-485
VIDEO
SUR-400
SCC-3100A
UTP CABLE
BNC CABLE
RS-485
User Guide
Notes
• U sing the product with third-party UTP peripherals may result in degradation of product
function and performance.
• A ttenuation and distortion in signal may occur if the maximum transmission distance is
exceeded. Please note that depending on the installation environment/condition, the
signal may become attenuated and distorted and cause the camera to function
incorrectly even when the transmission distance is within the maximum.
• I f using RS-485 communication, please use the STW(SPD), Pelco-P, Pelco-D, Vicon,
Panasonic, Bosch, Honeywell and SEC Protocol.
• I f you are using the 1Ch Passive Receiver system setup, please connect the power
supply directly to the camera.
• D on't simultaneously connect both BNC CABLE and UTP CABLE with camera.
If the distance between the camera and the Junction Box exceeds
300m, please connect an AC 24V or DC 12V power supply to the
Power Input Terminal Block(Accessory). Impressing power when
the maximum transmission distance is exceeded may result in
degradation of picture quality or even camera failure.
15
COLOR CCD CAMERA
User Guide
Advertisement
Table of Contents
