Table of Contents
Advertisement
Installation
When Using Auto Iris Lens
1. Strip the insulation of the auto iris lens
cable 8mm from the end.
8mm
3. Remove the cover of the auto iris lens connector plug and solder the lens cable to the
connector pin of the plug.
LENS
Pin No.
DC
VIDEO
No.1 Pin
Damping -
Red (power)
No.2 Pin
Damping +
NC
No.3 Pin
Drive +
White (video signal)
No.4 Pin
Drive -
Black (GND)
4. Please replace the auto iris lens connection plug cover and take off the CCD protection
cap, and then attach the auto iris lens to the camera
by screwing it in clockwise.
5. Please insert the connection plug that is connected to
the auto iris lens cable into the auto lens connector,
which is located on the side of the camera.
When using a C-Mount lens
Please take off the CCD protection cap and attach the C-Mount lens to
the camera by screwing it in clockwise.
12
COLOR CCD CAMERA
2. Strip the insulation of the core of the auto
iris lens cable to expose a 2mm length.
2mm
Lens cable
Connector
No.3 Pin
No.1 Pin
No.4 Pin
No.2 Pin
C-mount adaptor
User Guide
When using a CS-Mount lens
1. Please take off the CCD protection cap
and C-mount adaptor.
C-mount adaptor
CCD protection cap
Notes
• Please use the specified lens connection parts as shown in the picture below.
The use of the wrong sized parts may cause damage to the inside of the camera or
result in poor fitting.
• Use of a lens which is too heavy affects the balance of the
camera and may cause a malfunction. Please use a lens
that weighs less than 450g.
• Please select Av mode if possible when adjusting the
automatic light control (ALC) of an auto lens. Use of PK
mode may cause hunting.
COLOR CCD CAMERA
2. Please attach the CS-Mount lens to the
camera by screwing it in clockwise.
CS-mount adaptor
C-mount lens : 10 mm or less
CS-mount lens : 5 mm or less
13
User Guide
Advertisement
Table of Contents
