D-Link DAP-3690 Reference Manual page 22

WAP0-> tftp putconfig dap3 3 3 3 690.dcf 1.49.12.1
tftp: The putconfig configuration file was successful.
The following is an example of using TFTP to get firmware from a PC, using the format tftp getfirmware
[firmware file name] [host IP address].
WAP0-> tftp getfirmware dap3 3 3 3 690-firmware-v100-r0018.bin 1.49.12.1
head in flash
Burning done!
Once the user has determined what type of authentication is best for their wireless network, follow the
appropriate instructions below.
The following is an example in which authentication is set to Open System.
WAP0-> set authentication open-system
WAP0-> set cipher no
WAP0-> set apply
The following is an example in which the authentication is set to Shared-Key.
WAP0-> set authentication shared-key
WAP0-> set key 1 1234567890
WAP0-> set defkeyindex 1
WAP0-> set cipher wep
WAP0-> set apply
The following is an example in which the authentication is set to WPA-PSK.
WAP0-> set authentication wpa-psk
WAP0-> set cipher auto
WAP0-> set passphrase 1234567890
WAP0-> set apply
The following is an example in which the authentication is set to WPA-EAP.
WAP0-> set authentication wpa-eap
WAP0-> set cipher auto
WAP0-> set radiusip 192.168.0.88
WAP0-> set radiussecret
WAP0-> set apply
The following is an example in which the authentication is set to WPA2-EAP.
WAP0-> set authentication wpa2-eap