Procedure 4: Tighten Seat Carraige - Spirit XBU75 Service Manual

PROCEDURE 4: Tighten seat carraige

If the seat assembly on the recumbent bike is loose and wobbles from side to side, follow these
instructions to tighten it up.
(Front wheel assembly on Left side)
"A"
Push down
on wrench
(Rear wheel assembly on Left side)
1. Loosen the nyloc nut (B) with a 13mm wrench.
2. Press down on (A) with an 11mm wrench.
3. While pressing down on (A), tighten the nyloc nut (B).
4. Use this procedure on all 4 seat wheel assemblies.
There are two wheels on each assembly. By pressing down on (A) you are turning the assembly so
that the inside wheel (which is connected to "B") is pressed to the top of the track while the outer
wheel (which is connected to "A") remains pressed to the bottom of the track.
"B"
"B"
"A"
Push down
on wrench
7