Screw In Cap - Lincoln Electric INVERTEC V350-PRO Service Manual

F-67
REMOVAL AND REPLACEMENT (continued)
18. Replace the Advanced Process board.
19. Replace the two phillips head screws at the
bottom of the advanced process board.
20. Perform the Remote Board Replacement
Procedure.
21. Replace the 9/16" nuts and their washers
behind the "Adjust" and "Select" knobs.
22. Using a small screwdriver replace the two
knobs previously removed.
23. Replace the three 5/16" screws previously
removed from the front of the machine located
around the Advanced Process board.
24. Reconnect plug #J33 previously removed.
TROUBLESHOOTING & REPAIR
ADVANCED PROCESS PANEL
FIGURE F.28. – SCREW IN CAP
V350-PRO
Small Flathead
Screwdriver
25. Replace the four phillips head screws removed
from the front of the machine located around
the two welder output terminals.
26. Replace the two flat head screws and their
washers from around the input power switch.
27. Using a 5/16" nut driver replace the two
screws previously removed from the bottom
front of the machine
28. Replace the case wraparound cover.
F-67