Lincoln Electric INVERTEC V350-PRO Service Manual page 115

F-65
REMOVAL AND REPLACEMENT (continued)
Phillips Head
Screws
5. Using a 5/16" nut driver remove the two screws
from the bottom of the front of the machine.
See Figure F.26.
6. Using a flat head screwdriver remove the two
screws and their washers from above and
below the input power switch.
F.26..
TROUBLESHOOTING & REPAIR
ADVANCED PROCESS PANEL
FIGURE F.26. – CASE FRONT SCREW REMOVAL
A
MPS
CONTROL
REMOTE REMOTE
LOCAL LOCAL
SELECT
MEMOR MEMORY BUTT BUTTON ON
SELECT KNOB SELECT KNOB
_
5/16" Screws
See Figure
V350-PRO
V
OLTS
WELD TERMINALS
REMOTE REMOTE
ON ON
OUTPUT
SELECT
SELECT SELECT ATTRIBUTE TTRIBUTE
ADJUST ADJUST ATTRIBUTE TTRIBUTE
+
7. Using a phillips head screwdriver remove the
four screws from around the two welder output
terminals on the front of the machine. See
Figure F.26.
8. The front of the machine may now gently be
pulled forward to gain access to the mode
board. Note: The front of the machine cannot
be removed completely, only pulled forward a
few inches.
F-65
Flathead Screws