D-Link DSL-2730E User Manual page 77

DSL-2730E User Manual
3.3.12.2 IPv6 Static Route
Choose Advanced > Routing > IPv6 Static Route. The IPv6 Routing
Configuration page shown in the following figure appears. This page is used to
configure the routing information. You can add or delete IP routes.
The following table describes the parameters and buttons of this page.
Field
Destination
Prefix Length
Next Hop
Interface
Add Route
Delete
Selected
3.3.12.3 RIP
Enable this function if you are using this device as a RIP-enabled router to
communicate with others using Routing Information Protocol (RIP). This page is
used to select the interfaces on your devices that use RIP, and the version of the
protocol used.
Enter the IPv6 address of the destination device.
Enter the prefix length of the IPv6 address.
Enter the IP address of the next hop in the IPv6 route to
the destination address.
The interface for the specified route.
Click it to add the new static route to the IPv6 Static
Route Table.
Select a row in the IPv6 Static Route Table and click it to
delete the row.
Description
74