Selecting An Operating Mode; Setting The Temperature Set Point; Selecting The Direction Of Louver Position - Carrier Air Conditioner Owner's Manual

Selecting an Operating Mode —
button to select the unit operating mode.
Repeatedly press the Operating Mode button to select avail-
able modes.
The chosen mode is shown as follows, while the unit will
acknowledge signal receipt with a beep.
Indicated symbol:
Fan Only
Heating
Automatic
Cooling
Dehumidification
Setting the Room Temperature Set Point —
Pressing the increase temperature set point
buttons will raise or lower the temperature.
The unit will confirm signal receipt with a beep, and the
value of the set temperature on the display will change
accordingly.
The temperature can be set between 63 F and 90 F at
1 degree intervals.
NOTE: In Cooling mode, if the temperature selected is higher
than the room temperature the unit will not start; the same
applies for the Heating mode, if the selected temperature is
lower than the room temperature.
The remote control can be set to display the temperature in
degrees Fahrenheit or degrees Celsius. To change the tempera-
ture setting, complete the following steps while the unit is off:
1. Press the decrease set point button and the louver button
simultaneously for 5 seconds.
Fig. 7 — Unit Display and Switch Panel
Use the
and decrease
6
2. The display will show the channel setting (CH).
3. Press the mode button once to go to the Temperature
(tu) screen.
4. Use the increase or decrease set point arrows to change
the temperature display setting.
5. Press the louver button to transmit the temperature dis-
play setting to configure the remote.
Selecting the Direction of Louver Posi-
The airflow direction can be adjusted to
tion —
optimize air distribution.
Press the louver button
louver positions. See Table 1.
In the Cooling, Dehumidification and Fan Only mode, the
louver will swing in the cooling range. In the Heating mode,
the louver will swing in the heating range. See Fig. 8.
NOTE: Always use the remote control to adjust the louver
position, otherwise abnormal operation may occur. If the
louver is manually adjusted out of its range, turn the unit off
and then on again.
Fig. 8 — Cooling and Heating Louver Position
repeatedly to choose one of the