Indoor Unit Display; Emergency Operation; Pressing The On/Off Button; Louver Positions - Carrier Air Conditioner Owner's Manual

Fig. 6 — Proper Positioning of Remote Control
Table 1 — Louver Positions
SYMBOL ON
REMOTE CONTROL
Louver position will be set automatically.
Louver will be set to the preset position
according to the operation mode.
The louver can be set to one of
six different airflow directions.
The louver will continuously swing
up and down. The "swing" setting will
provide optimal, even air distribution
in the room.
Indoor Unit Display (Fig. 7) —
play has three LED indicators at the lower right hand portion of
the unit. The Blue light is illuminated when the ionizer is
Fig. 5 — Operating Mode Indicators on Remote Control
DESCRIPTION
The indoor unit dis-
Display readout
A. Mode selection button
B. ON/OFF button
C. Increase temperature button
D. Decrease temperature button
E. Fan speed selection button
F . Turbo setting button
G. Economical setting button
H. Louver control button (Flap)
I. ON timer button
J. DAILY timer button (Everyday)
K. Cancel timer button / Current time
button
L. OFF timer button
M. Sleep timer button (night)
N. Ionizer button
O.
Reset button
active. The Orange light is illuminated during timer mode. The
Green light is illuminated during operation.
Emergency Operation —
lost or damaged or the batteries are exhausted, the EMER.
button can be used to run the unit.
Press the EMER. button once briefly when the system is off.
To stop emergency operation, push the EMER. button again
or operate the remote control.
The set conditions of emergency operation are as follows:
• Preset set point: 77 F
• Fan speed: AUTO
• Timer mode: Disabled
• Discharge air direction: Pre-set position based on opera-
tion in "Cool" or "Heat" mode.
Pressing the On/Off Button —
air conditioner is not in operation, the remote
control readout will display the time of day only.
Press the On/Off button to start the unit.
The unit will start in the last operating mode.
Press button On/Off to stop the unit.
All indicator lights on the unit will go out, and the remote
control will display only the current time.
If the unit does not stop, turn the control on (by pressing the
On/Off button) and repeat the operation.
NOTE: If the On/Off button is pressed too soon after a stop,
the compressor will not start for 3 to 5 minutes due to the
inherent protection against frequent compressor cycling. The
unit will only emit an audible beep when the signals are
received correctly.
5
When the remote control is
When the