Scanner(s) To Cradle Support
Modes of Operation
The charging cradle with radio supports two radio communication modes of operation, allowing the scanner to communicate
wirelessly:
• Point-to-Point
• Multipoint-to-Point.
Point-to-Point Communication
In Point-to-Point communication mode, the cradle allows one scanner to connect to it at a time. In this mode, the scanner is paired to
the cradle either by insertion into the cradle (if pairing on contacts is enabled), or by scanning the PAIR bar code on the cradle.
Communication can be locked, unlocked (default), or in a lock override state (see
intervals must be set by scanning a connection maintenance interval bar code beginning on
To activate this mode of operation, scan Point-to-Point.
Multipoint-to-Point Communication
In Multipoint-to-Point communication mode, up to three scanners can be paired to one cradle.
To activate this mode of operation, the Multipoint-to-Point bar code must be scanned by the first scanner connected to the cradle.
This communication mode is always locked (see
maintenance interval bar code beginning on
paired to the cradle so only one scanner needs to be programmed.
The number of scanners is dependent on the host's capability.
To select Point-to-Point or Multipoint-to-Point mode, scan the appropriate bar code.
Multipoint-to-Point Mode
Pairing Modes on page
4-26). Locking intervals must be set by scanning a connection
page
4-28. This mode allows a parameter broadcast
Pairing Modes on page
4-26). In locked mode, locking
page
4-28.
(page
4-26) that clones all scanners
*Point-to-Point Mode
Radio Communications 4-25